Molded gaskets, o-rings and radial shaft seals

Quarter light gasket, nitrosamine reducing; 65 Shore A; EPDM; sulfur cure, injection molding (K 91-59)
Molded parts for automotive seals, ASTM D2000, replacement of carbon black N-990; 70 Shore A; NBR; sulfur cure (M 630.0/7) (M 630.0/6) (M 630.0/5) (M 630.0/3) (M 630.0/2) (M 630.0/1)
Parts with moderate resistance to lubricants and fuel, thermally stressable 100-130°C; 70 Shore A; CR; injection / transfer molding (T.I.B. 4.1.2)
Quarter light gasket, Renault 2 6 07 B1; 60 Shore A; EPDM; sulfur cure, injection / transfer molding (911 C 152)
Corner molding for sponge seals; 30 Shore A; EPDM; sulfur cure (A.1.4.002)
Quarter light gasket; 50 Shore A; EPDM; sulfur cure (A.4.0.003)

Download all

Recommended Products

Sorted by crosslinking agent.

Name	Short Description
SILLITIN N 75	Standard product for non-critical compounds with low requirements.
SILLITIN N 85	Standard product for slightly higher requirements for color and dispersion, low compression set.
SILLITIN Z 86	Standard product, less wear than Sillitin N products.
SILLIKOLLOID P 87	Higher tensile strength and tear resistance, least wear.
SILFIT Z 91	Same as N 85, but with avoidance of mold fouling caused by filler, greater brightness and color neutrality, less moisture content, improved dispersion, very fine cell structure in sponge rubber parts.

Name	Short Description
AKTISIL PF 216	Same as Aktisil MM, but with highest tensile strength and tensile modulus, lowest compression set, best abrasion resistance, best chemical resistance.
AKTIFIT AM	Same as Silfit Z 91, but with higher tensile strength, higher tensile modulus and lower compression set, better abrasion resistance, improved resistance.

Name	Short Description
AKTISIL VM 56	Same as Sillitin Z 86, but with higher tensile strength, higher tensile modulus and lower compression set, better abrasion resistance, improved chemical resistance.
AKTISIL VM 56/89	Same as Aktisil VM 56, but for greater color neutrality requirements and slightly improved dispersion.
AKTISIL Q	Similar to Aktisil VM 56/89 but with less moisture content, lower viscosity, lower compression set, improved resistance, best product for silicone rubber.
AKTIFIT VM	Same as Silfit Z 91, but with higher tensile strength, higher tensile modulus and lower compression set, better abrasion resistance, improved chemical resistance.
AKTIFIT Q	Same as Silfit Z 91, but with higher tensile strength, highest tension value and lowest compression set, better abrasion resistance, improved chemical resistance.

Name	Short Description
AKTIFIT AM	Same as Silfit Z 91, but with higher tensile strength, higher tensile modulus, lower compression set, better abrasion resistance, improved resistance, improved chemical resistance.